Vehicles Not Equipped With Keyless Enter-N-Go

1. Turn the ignition switch to the ON/RUN position (Do not start the engine.) 2. Fully depress the accelerator pedal, slowly, three times within 10 seconds.

3. Turn the ignition switch to the OFF/LOCK position.

NOTE:
If the indicator message illuminates when you start the engine, the oil change indicator system did not reset. If necessary, repeat these steps.

    See also:

    Power Steering Fluid Check
    Checking the power steering fluid level at a defined service interval is not required. The fluid should only be checked if a leak is suspected, abnormal noises are apparent, and/or the system is ...

    Using The RKE Transmitter
    Three-button RKE transmitters will provide basic UNLOCK, LOCK and PANIC functions. Key Fob With Three-Button RKE Transmitter Seven-button RKE transmitters will provide functions that allow the ...

    Gross Vehicle Weight Rating (GVWR)
    The GVWR is the total allowable weight of your vehicle. This includes driver, passengers, cargo, and tongue weight. The total load must be limited so that you do not exceed the GVWR. Refer to “ ...