To Reinstall The Basic Floor Console

1. Position the console at a slight angle (front slightly higher than the rear).

2. Slide the console rearward into the floor bracket/ hook.

3. Align the console until the front anchor cup plug hole is centered on the winch hole.

4. Reinstall the clip first and then while pushing downward on the console with slight pressure, reinstall the cover plug.

5. Pull up on the console to be sure it is firmly latched.

WARNING!
In an accident, serious injury could result if the removable floor console is not properly installed. Always be sure the removable floor console is fully latched.

    See also:

    Answer Or Ignore An Incoming Call — No Call Currently In Progress
    When you receive a call on your mobile phone, the Uconnect™ Phone will interrupt the vehicle audio system, if on, and will ask if you would like to answer the call. Press the button to accept ...

    Redial
    • Press the button to begin. • After the “Ready” prompt and the following beep, say “Redial”. • The Uconnect™ Phone will call the last number that was dialed from your mobile ph ...

    Extreme Cold Weather (Below –20°F Or 29°C)
    To ensure reliable starting at these temperatures, use of an externally powered electric engine block heater (available from your dealer) is recommended. ...