Instrument Panel Cupholders
The instrument panel cupholders are located in a pull-out drawer just above the lower storage bin.

Front Cupholders
Pull the drawer out firmly until it stops, and place the container to be held in either one of the cupholder wells.
The cupholders are designed to accommodate a wide variety of container types and sizes. Press down on the container to engage the cupholder retention features.
See also:
General Information
The Sentry Key system complies with FCC rules Part 15
and with RSS-210 of Industry Canada. Operation is
subject to the following conditions:
• This device may not cause harmful interference.
â ...
Blind Spot Monitoring — If Equipped
The Blind Spot Monitoring (BSM) system uses two radarbased
sensors, located inside the rear bumper fascia, to
detect highway licensable vehicles (automobiles, trucks,
motorcycles, etc.) that ent ...
General Information
• You can start out, from a stop, in any gear except sixth.
The system will ignore attempts to upshift at too low
of a vehicle speed.
• If a ratio other than first gear is selected, and the
...
