Before You Begin Programming HomeLink

Be sure that your vehicle is parked outside of the garage before you begin programming.

For more efficient programming and accurate transmission of the radio-frequency signal it is recommended that a new battery be placed in the hand-held transmitter of the device that is being programmed to the HomeLink system.

Erase all channels before you begin programming. To erase the channels place the ignition in the ON/RUN position and press and hold the two outside HomeLink buttons (I and III) for up 20 seconds or until the red indicator flashes.

NOTE:
• Erasing all channels should only be performed when programming HomeLink for the first time. Do not erase channels when programming additional buttons.
• If you have any problems, or require assistance, please call toll-free 1–800–355–3515 or, on the Internet at www.HomeLink.com for information or assistance.

    See also:

    Towing Assistance
    If you need towing assistance: • Press the button to begin. • After the “Ready” prompt and the following beep, say “Towing Assistance”. NOTE: • The towing assistance number dialed ...

    Protection Of Body And Paint From Corrosion
    Vehicle body care requirements vary according to geographic locations and usage. Chemicals that make roads passable in snow and ice and those that are sprayed on trees and road surfaces during o ...

    2011 Chrysler 200: First Drive
    The one vehicle in Chrysler's shrinking lineup in most need of a makeover is the Sebring midsize sedan. From day one of its last redesign in 2007, it never seriously challenged the class leaders. ...