Turning Parkview On Or Off — With Navigation/Multimedia Radio


 

1. Press the “menu” hard-key.

2. Select “system setup” soft-key.

3. Press the “camera setup” soft-key.

4. Enable or disable the rear camera feature by selecting “enable rear camera in reverse” soft-key.

5. Press the “save” soft-key.

    See also:

    Preparations For Jump-Start
    The battery in your vehicle is located between the left front headlight assembly and the left front wheel splash shield. To allow jump-starting there are remote battery posts located on the left ...

    To Exit Remote Start Mode And Drive The Vehicle
    Before the end of 15 minute cycle, press and release the UNLOCK button on the RKE transmitter to unlock the doors and disarm the Vehicle Security Alarm (if equipped). Then, prior to the end of t ...

    Front Heated Seats
    There are two heated seat switches that allow the driver and passenger to operate the seats independently. The controls for each heater are located on the switch bank below the climate controls. ...