Windshield Wipers And Washers
The wipers and washers are operated by a switch within the multifunction lever. Rotate the end of the multifunction lever to select the desired wiper speed.
NOTE:
Always remove any buildup of snow that prevents
the windshield wiper blades from returning to the
off position. If the windshield wiper switch is turned off
and the blades cannot return to the off position, damage
to the wiper motor may occur.
Washer And Wiper Controls
See also:
To Open And Close The Hood
To open the hood, two latches must be released.
1. Pull the hood release lever located on the instrument
panel, below the steering column.
Hood Release
2. Move to the front of the vehicle and l ...
Selecting Uconnect™ Multimedia (Satellite) Mode
Press the SAT button until SAT appears in the display.A
CD may remain in the radio while in the Satellite radio
mode. ...
LOW – If Equipped
This range should be used for engine braking when
descending very steep grades. In this range, the transmission
will downshift for increased engine braking. To
switch between DRIVE and LOW modes ...