Redial


 

• Press the • After the “Ready” prompt and the following beep, say button to begin.

• After the “Ready” prompt and the following beep, say “Redial”.

• The Uconnect™ Phone will call the last number that was dialed from your mobile phone.

NOTE:
This may not be the last number dialed from the Uconnect™ Phone.

    See also:

    Key Fob
    The Key Fob operates the ignition switch. Insert the square end of the key fob into the ignition switch located on the instrument panel and rotate to the desired position. It also contains the Re ...

    Check TPMS Warning
    When a system fault is detected, a chime will sound and the “Tire Pressure Monitoring Telltale Light” will flash on and off for 75 seconds and then remain on solid. In addition, the EVIC wil ...

    Toggling Between Calls
    If two calls are in progress (one active and one on hold), press the button until you hear a single beep, indicating that the active and hold status of the two calls have switched. Only one c ...