Toggling Between Calls


 

If two calls are in progress (one active and one on hold), press the single beep, button until you hear a single beep, indicating that the active and hold status of the two calls have switched. Only one call can be placed on hold at a time.

    See also:

    Daytime Running Lights — If Equipped
    The front turn signal lamps will turn on as Daytime Running Lights whenever the ignition is ON, the engine is running, the headlight switch is off, the parking brake is released and the shift le ...

    To Vary The Speed Setting
    When the Electronic Speed Control is set, you can increase speed by pushing the RES (+) button. If the button is continually pressed, the set speed will continue to increase until the button is ...

    Quad Headlamps
    1. Raise the hood to access the high or low beam bulbs at the rear of the headlamp housing. 2. Release the two tabs on the side of the connector and remove the connector from the bulb. 3. Twist ...