Place/Retrieve A Call From Hold


 

To put a call on hold, press the button until you hear button until you hear a single beep. This indicates that the call is on hold. To bring the call back from hold, press and hold the button until you hear a single beep. button until you hear a single beep.

    See also:

    Programming A Non-Rolling Code
    For programming Garage Door Openers manufactured before 1995. 1. Turn the ignition switch to the ON/RUN position. 2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink ...

    Nav–Turn By Turn
    When this feature is selected, the navigation system utilizes voice commands, guiding through the drive route, mile by mile, turn-by-turn until the final destination is reached. To make your sel ...

    Elapsed Time
    Shows the total elapsed time of travel since the last reset. Elapsed time will increment when the ignition switch is in the RUN or START position. Elapsed time is displayed as follows: hours:minu ...