When To Reset Remote Start

The vehicle can be started remotely up to a maximum of two times. The vehicle is also allowed a maximum of one failed start, where the Remote Starting sequence was initiated but the engine stopped cranking without starting.

After either of these conditions, or if the Vehicle Security Alarm system is alarming, or if the PANIC button was pressed, the vehicle must be reset by cycling the START/STOP button to the ON/RUN position.

    See also:

    iPod /USB/MP3 Control — If Equipped
    NOTE: This section is for sales code RES and REQ/ REL/RET radios only with Uconnect™. For sales code RBZ/RHB, RHR, RHP, RHW or RB2 touch-screen radio iPod /USB/MP3 control feature, refer to t ...

    Recent Calls
    You may browse up to 34 of the most recent of each of the following call types: • Incoming Calls • Outgoing Calls • Missed Calls • All Calls These can be accessed by touching the “r ...

    Vehicles Equipped With Keyless Enter-N-Go
    1. Without pressing the brake pedal, push the ENGINE START/STOP button and cycle the ignition to the ON/ RUN position (Do not start the engine.) 2. Fully depress the accelerator pedal, slowly, t ...