To Enter Remote Start Mode

Press and release the REMOTE START button

Press and release the REMOTE START button on the RKE transmitter twice within five seconds.

The vehicle doors will lock, the parking lights will flash and horn will chirp twice (if programmed). Then, the engine will start and the vehicle will remain in the Remote Start mode for a 15-minute cycle.

NOTE:
• If your power door locks were unlocked, Remote Start will automatically lock the doors.
• The park lights will turn on and remain on during Remote Start mode.
• For security, power window and power sunroof operation (if equipped) are disabled when the vehicle is in the Remote Start mode.
• The engine can be started two consecutive times (two 15 minutes cycles) with the RKE transmitter. However, the ignition switch must be cycled by pushing the START/STOP button twice (or the ignition switch must be cycled to the ON/RUN position).

    See also:

    The Verdict
    The Town & Country Limited I tested was priced at the heady sum of $44,480, but that included many of the features that make the Town & Country a good van to buy if you have passengers to ...

    Towing Tips
    Before setting out on a trip, practice turning, stopping and backing the trailer in an area away from heavy traffic. ...

    Delete/Erase “All” Uconnect™ Phonebook Entries
    • Press the button to begin. • After the “Ready” prompt and the following beep, say “Phonebook Erase All”. • The Uconnect™ Phone will ask you to verify that you wish to delete a ...