To Exit Remote Start Mode And Drive The Vehicle

Before the end of the 15 minute cycle, press and release the UNLOCK button on the RKE transmitter to unlock the doors and disarm the Vehicle Security Alarm (if equipped). Then insert the key into the ignition switch and turn the switch to the ON/RUN position.

NOTE:
The ignition switch must be in the ON/RUN position in order to drive the vehicle.

    See also:

    License Lamp
    The license plate lamp is located under the tailgate light bar and above the license plate. 1. Using a small screwdriver, press inward the locking tab on the outboard side of the lamp assembly an ...

    Trailer Tongue Weight (TW)
    The TW is the downward force exerted on the hitch ball by the trailer. In most cases it should not be less than 10% or more than 15% of the trailer load. You must consider this as part of the lo ...

    Window Lockout Switch
    The window lockout switch on the driver’s door trim panel allows you to disable the window controls on the rear passenger doors and the rear sunscreen (if equipped). To disable the window cont ...