To Arm The System
Follow these steps to arm the Vehicle Security Alarm:
1. Remove the key from the ignition system (refer to Starting Procedures in Starting And Operating for further information).
• For vehicles equipped with Keyless Enter-N-Go, make sure the vehicle ignition system is OFF .
• For vehicles not equipped with Keyless Enter-N-Go, make sure the vehicle ignition system is OFF and the key is physically removed from the ignition.
2. Perform one of the following methods to lock the vehicle:
• Press LOCK on the interior power door lock switch with the driver and/or passenger door open.
• Press the LOCK button on the exterior Passive Entry Door Handle with a valid Key Fob available in the same exterior zone (refer to Keyless Enter-N-Go in Things To Know Before Starting Your Vehicle for further information).
• Press the LOCK button on the Remote Keyless Entry (RKE) transmitter.
3. If any doors are open, close them.
See also:
Seats
Seats are a part of the Occupant Restraint System of the
vehicle.
WARNING!
• It is dangerous to ride in a cargo area, inside or
outside of a vehicle. In a collision, people riding in
these a ...
Programming Additional Transmitters
If you do not have a programmed RKE transmitter,
contact your authorized dealer for details. ...
Adding Coolant
Your vehicle has been built with an improved engine
coolant (antifreeze) that allows extended maintenance
intervals. This engine coolant (antifreeze) can be used up
to five years or 104,000 mile ...