Clearing A Flooded Engine (Using ENGINE START/STOP Button)

Chrysler 300 / Chrysler 300 Owners Manual / Starting And Operating / Starting Procedures / If Engine Fails To Start / Clearing A Flooded Engine (Using ENGINE START/STOP Button)

 

If the engine fails to start after you have followed the “Normal Starting” or “Extreme Cold Weather procedures, it may be flooded. To clear any excess fuel, press and hold the brake pedal, push the accelerator pedal all the way to the floor and hold it, then press and release the ENGINE START/STOP button once. The starter motor will engage automatically, run for 10 seconds, and then disengage. Once this occurs, release the accelerator pedal and the brake pedal, wait 10 to 15 seconds, then repeat the “Normal Starting” procedure.

    See also:

    ESC Operating Modes
    The “ESC Off” switch is located in the center switch bank, next to the hazard flasher switch. ESC On This mode is the normal operating mode for ESC on two-wheel drive vehicles. Whenever ...

    Supplemental Side Air Bag Inflatable Curtain (SABIC)
    SABIC air bags may offer side-impact protection to front and rear seat outboard occupants in addition to that provided by the body structure. Each air bag features inflated chambers placed adjac ...

    Without The Ignition Key
    Special care must be taken when the vehicle is towed with the ignition in the LOCK position. Flatbed towing is the preferred towing method. However, if a flatbed towing vehicle is not available, ...