Enhanced Seat Belt Use Reminder System (BeltAlert )

BeltAlert is a feature intended to remind the driver and front passenger (if equipped with front passenger BeltAlert ) to fasten their seat belts. The feature is active whenever the ignition is on. If the driver or front seat passenger is unbelted, the Seat Belt Reminder Light will turn on and remain on until both front seat belts are fastened.

The BeltAlert warning sequence begins after the vehicle speed is over 5 mph (8 km/h), by blinking the Seat Belt Reminder Light and sounding an intermittent chime.

Once the sequence starts, it will continue for the entire duration or until the respective seatbelts are fastened.

After the sequence completes, the Seat Belt Reminder Light remains illuminated until the respective seat belts are fastened. The driver should instruct all other occupants to fasten their seat belts. If a front seat belt is unbuckled while traveling at speeds greater than 5 mph (8 km/h), BeltAlert will provide both audio and visual notification.

The front passenger seat BeltAlert is not active when the front passenger seat is unoccupied. BeltAlert may be triggered when an animal or heavy object is on the front passenger seat or when the seat is folded flat (if equipped). It is recommended that pets be restrained in the rear seat in pet harnesses or pet carriers that are secured by seat belts, and cargo is properly stowed.

BeltAlert can be enabled or disabled by your authorized dealer. Chrysler Group LLC does not recommend deactivating BeltAlert .

NOTE:
Although BeltAlert has been deactivated, the Seat Belt Reminder Light will continue to illuminate while the driver’s or front passenger (if equipped with belt alert) seat belt remains unfastened.

    See also:

    Dealer Service
    Your authorized dealer has the qualified service personnel, special tools, and equipment to perform all service operations in an expert manner. Service Manuals are available which include detail ...

    Controlling The iPod Or External USB Device Using Radio Buttons
    To get into the iPod /USB/MP3 control mode and access a connected audio device, either press the “AUX” button on the radio faceplate or press the VR button and say USB or Switch to USB . Onc ...

    Stain Repel Fabric Cleaning Procedure – If Equipped
    Stain Repel seats may be cleaned in the following manner: • Remove as much of the stain as possible by blotting with a clean, dry towel. • Blot any remaining stain with a clean, damp towel. ...